Preparation
Special Service Tool
|
Tool number (TechMate No.) Tool name | Description | |
|---|---|---|
|
KV40104001 (NI-53385) Hub lock nut wrench a: 85 mm (3.35 in) b: 65 mm (2.56 in) |
|
Removing and Installing wheel hub lock nut. |
|
KV40107300 (NI-51751) Boot band crimping tool |
|
Installing boot band |
|
KV40107310 (-) Boot band crimping tool |
|
Installing boot band |
|
KV40107500 (-) Drive shaft attachment |
|
Removing drive shaft |
|
KV38107900 (NI-33904) (NI-52469-1) Protector a: 32 mm (1.26 in) dia. b: 25 mm (0.98 in) |
|
Installing drive shaft |
|
KV40108700 (-) Lock nut crimp punch a: 5 mm (0.20 in) b: 7 mm (0.28 in) |
|
Installing wheel hub lock nut |
|
KV40108800 (NI-52982) Lock nut chisel a: 44.5 mm (1.752 in) b: 10 mm (0.39 in) dia. c: 31 mm (1.22 in) d: 4.5 mm (0.177 in) e: 26 mm (1.02 in) f: 0.4 mm (0.016 in) g: 4 mm (0.16 in) h: 24 mm (0.94 in) |
|
Removing wheel hub lock nut |
Commercial Service Tool
| Tool name | Description | |
|---|---|---|
| Drive shaft puller |
|
Removing drive shaft joint sub assembly |
| Sliding hammer |
|
Removing drive shaft |
| Power tool |
|
Loosening bolts and nuts |
| Ball joint remover |
|
|
Lubricant or/and Sealant
| Name | Description |
|---|---|
| NISSAN Genuine grease or equivalent |
|
| Apply paste [service parts (440037S000)] |
|
Other materials
How to enable/disable the I-BSI system
Example
ProPILOT Assist switch (design may vary depending on the Nissan Armada model)
Vehicle information display
Steering-wheel-mounted control (right side)
To configure the Nissan Armada Intelligent Blind Spot Intervention (I-BSI) system,
follow these steps:
1. Press the
butt ...
Rear
Exploded View
Rear ventilator duct 1
Rear ventilator duct 2 RH
Rear ventilator grille housing
Rear ventilator grille
Rear ventilator connecting duct
Rear A/C unit assembly
Rear foot duct
Rear inlet duct
Rear ventilator duct 2 LH
: Clip
: Metal clip
: vehicle fro ...
Fusible Link Inspection
How To Check
With ProPILOT ASSIST 2.1A melted fusible link can be detected by visual inspection. If its condition is questionable, use circuit tester or test lamp.
Fusible link
CAUTION:
If fusible link should melt, it is possible that critical circuit (power supply ...










