Nissan Armada 2025-2026 Service and Repair Manual: Accelerator Pedal Released Position Learning
Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time the harness connector of the accelerator pedal position sensor or ECM is disconnected. (For details, refer to Work Procedure .)
Work Procedure
CHECK VIN
Check the VIN of the vehicle and note it. Refer to Information About Identification or Model Code.
>>
GO TO 2.
PERFORM VIN REGISTRATION
With CONSULT
Ignition switch ON and engine sto ...
Work Procedure
START
Make sure that accelerator pedal is fully released.
Ignition switch ON and wait at least 2 seconds.
Ignition switch OFF and wait at least 10 seconds.
Ignition switch ON and wait at least 2 secon ...
Other materials:
Removal and Installation
REMOVAL
CAUTION:
Never damage rear door glass and rear door panel.
Remove rear door glass run. Refer to Removal and Installation.
Remove rear door inner frame rear. Refer to Removal and Installation.
Fully close rear door glass.
Remove mounting bolt , and then remove rear door lower sash lower.
CA ...
Removal and Installation
REMOVAL
Drain engine coolant from cooling system. Refer to ENGINE COOLANT : Draining.
Remove engine cover. Refer to Removal and Installation.
Remove air inlet tube 1. Refer to Removal & Installation.
Remove front heater outlet pipe assembly mounting nuts and mounting bolt .
: Vehicle front ...
Adjustment
TOTAL PRELOAD TORQUE
Remove side shaft. Refer to Disassembly and Assembly.
Rotate drive pinion back and forth 2 to 3 times to check for unusual noise and rotation malfunction.
Rotate drive pinion at least 20 times to check for smooth operation of the bearing.
Measure total preload with the preload g ...
0.005