Description
When electric shift selector is replaced, always perform "Replace ECU" of CONSULT function to write vehicle specifications. For work procedure, refer to Work Procedure.
Work Procedure
WRITING VEHICLE SPECIFICATIONS
With CONSULT
-
Ignition switch ON.
-
Select "ELECTRIC SHIFTER".
-
Select "Replace ECU"
-
Perform the work according to the procedure displayed in CONSULT.
>>
GO TO 2.
CHECKING THE SELF-DIAGNOSIS RESULT
With CONSULT
Check the DTC.
Is the DTC detected?
YES>>Check the detected DTC. Refer to DTC Index.
NO>>WORK END
Other materials
Basic information
WARNING
Never attempt to lift two wheels of the Nissan Armada off the ground
while the engine is running and shift the transmission into any drive or reverse
position. This improper procedure may cause severe drivetrain damage or unexpected
vehicle movement, potentially leading to serio ...
Compressor Does Not Operate
Description
SYMPTOMCompressor does not operate.
Diagnosis Procedure
NOTE:
Perform self-diagnoses with CONSULT before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis.
Check that refrigerant is enclosed in cooler cycle normally. If refrigerant amount is s ...
Rear Door Finisher
Exploded View
Rear door panel
Inside seal
Rear door sash inner cover
Pull handle cap
Inside handle cap
Rear door finisher
Pull handle bracket
Grommet
: Clip
: Pawl
: N·m (kg-m, in-lb)
Rear Door Finisher
Removal and Installation
CAUTION:
Never da ...