Exploded View
 |
Instrument finisher A |  |
Indirect light LH |  |
Advanced ambient light (instrument panel driver side) |
 |
: Pawl | ||||
| : vehicle front | |||||
Removal and Installation
CAUTION:
Disconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal.
REMOVAL
Remove instrument pad A. Refer to Removal and Installation.
Remove indirect light LH fixing screws 
.
Disconnect harness connector, and then remove indirect light LH.
Disengage advanced ambient light (instrument panel driver side) fixing pawls using a remover tool (A), and then remove advanced ambient light (instrument panel driver side).
|
: Pawl |
INSTALLATION
Install in the reverse order of removal.
Replacement
CAUTION:
-
Disconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal.
-
Replacement of bulb is not possible due to the adoption of LED. When replacement, replace advanced ambient light (instrument panel driver side) as a single part. Refer to Removal and Installation.
Other materials
Precautions for Automatic Window Adjusting Function
PRECAUTIONS FOR AUTOMATIC WINDOW ADJUSTING FUNCTION : Precautions
Before disconnecting the battery, lower both the driver and passenger windows. This will prevent any interference between the window edge and the vehicle when the door is opened/closed. During normal operation, the window slightly rai ...
Precautions for Supplemental Restraint System (srs) Air Bag and Seat Belt Pre-Tensioner
PRECAUTIONS FOR SUPPLEMENTAL RESTRAINT SYSTEM (SRS) AIR BAG AND SEAT BELT PRE-TENSIONER : Precautions
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front p ...
Distance Sensor Alignment
Work Procedure
Always perform the radar alignment after removing and installing or replacing the distance sensor. Application Notice Type Description
TYPE 1
When using KV99112700 for radar alignment. Refer to Description.
TYPE 2
When using 1-20-2851-1 for radar alignment. Refer to Descript ...