Exploded View

![]() |
Clip A | ![]() |
Air breather tube | ![]() |
Clip B |
![]() |
Air breather hose A | ![]() |
Clip C | ![]() |
Clip D |
![]() |
Hose connector | ![]() |
Air breather hose B | ![]() |
Bracket |
![]() |
Clip E | ![]() |
Hose clamp | ![]() |
Air breather |
![]() |
Rear final drive assembly | ||||
| : vehicle front | |||||
: N·m (kg-m, in-lb) |
|||||
: Always replace after every disassembly. |
|||||
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Remove the hose clamp
and separate air breather hose B
from air breather
.

Remove clip E
from bracket
.

Remove bracket mounting bolt (
) and remove bracket
.

Remove clip D
from body frame
.

Remove clip C
from body frame
.

Remove air breather hose A
from air breather tube
.

Remove air breather hose assembly.
Remove clip B
from bracket
.

Remove clip A
from bracket
and remove air breather tube.

Separate each component part.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
For non-reusable parts, refer to Exploded View.
-
When inserting air breather hose A to air breather tube, align the paint mark
of air breather hose A with the paint mark
of breather tube.
-
When inserting air breather hose to hose connector
, be sure to insert it fully until its end reaches the stop.CAUTION:
Align paint mark
on each air breather hose.
-
When installing air breather to final drive assembly, Install air breather so that the paint mark
on it faced forward of the vehicle.
: vehicle front -
When inserting air breather hose B into the air breather, align paint mark
on air breather hose B and tab on the hose clamp
with the paint mark
on the air breather.
Other materials
Precautions for Pop up Engine Hood
PRECAUTIONS FOR POP UP ENGINE HOOD : Precautions
WARNING:
Always observe the following items for preventing accidental activation.
Before removal or installation of the pop-up engine hood and harness, always OFF the ignition switch, disconnect the battery negative terminal, and wait for 3 minutes ...
Additional Service When Replacing Ipdm E/r
Description
After replaced IPDM E/R, it is necessary to perform control unit configuration. For details, refer to Work Procedure.
Work Procedure
REPLACE IPDM E/R
Replace IPDM E/R. Refer to Removal and Installation.
>>
GO TO 2.
WRITING vehicle SPECIFICATION
Perform configuration (IPDM E/R). R ...
General Maintenance
General Maintenance
General maintenance includes those items which should be checked during the normal day-to-day operation of the vehicle. They are essential if the vehicle is to continue operating properly. The owners can perform checks and inspections themselves or have their INFINITI retailers d ...










: N·m (kg-m, in-lb)
: Always replace after every disassembly.