Removal and Installation
REMOVAL
Remove front seat LH. Refer to Removal and Installation.
Remove front kicking plate inner LH and rear kicking plate inner LH. Refer to Removal and Installation.
Remove dash side finisher LH. Refer to Removal and Installation.
Remove center pillar lower garnish LH. Refer to Removal and Installation.
Flip the carpet to allow the work space.
Remove the around view monitor control unit mounting bolt 
and nuts 
, and then remove the around view monitor control unit 
.
| : vehicle front |
Disconnect the around view monitor control unit harness connectors.
INSTALLATION
Installation is the reverse order of removal.
CAUTION:
Perform the “ADDITIONAL SERVICE WHEN REPLACING AROUND VIEW MONITOR CONTROL UNIT” when after replacing around view monitor control unit. Refer to Description.
Other materials
VR35DDTT ENGINE MODEL
Basic information
This section outlines the detailed maintenance schedule specifically designed
for the Nissan Armada equipped with the VR35DDTT engine, ensuring long-term durability,
optimal performance, and safe operation under a wide range of driving conditions.
Select the most appropriate ...
Vehicle Jerks During
Description
The vehicle jerks when VDC function, TCS function, ABS function, EBD function, brake limited slip differential (BLSD) function, brake assist function, hill start assist function, advanced hill descent control function (4WD models) and trailer sway control function operates.
Diagnosis Pro ...
Vin Registration
Work Procedure
VIN Registration is an operation to register the VIN in ADAS control unit.CHECK VIN
Check VIN of vehicle and note it. For VIN stamped position, refer to Information About Identification or Model Code .
>>
GO TO 2 .
PERFORM VIN REGISTRATION
With CONSULT
Ignition switch ON.
...