Inspection Procedure
CHECK 12V BATTERY TERMINALS CONNECTION
Check if 12V battery terminals are clean and tight.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair 12V battery terminals connection.
CHECK “B” TERMINAL CONNECTION
Check if “B” terminal (alternator ground harness) is clean and tight.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair “B” terminal connection.
CHECK 12V BATTERY STATUS
Check 12V battery status. Refer to Work Flow.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Replace 12V battery. Refer to Removal and Installation.
CHECK DRIVE BELT TENSION
Check drive belt tension. Refer to Inspection.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Repair as needed.
Other materials
Blower Unit
Exploded View
Front heater & cooling unit assembly
In-cabin microfilter
Filter cover
Front blower motor
A/C auto amp.
Front blower unit
Intake door motor
: Pawl
: vehicle front
Removal and Installation
REMOVALRemove front heater & ...
Noise
Symptom Table
Symptom Noise source Probable cause Corrective action
Unusual noise from A/C compressor when A/C is ON.
Inside of A/C compressor
Wear, breakage, or clogging of foreign material in inner parts.
Check A/C compressor oil. Refer to Inspection.
Magnet clutch
Contact of clut ...
Distance Sensor
Exploded View
Front bumper reinforcement
Distance sensor bracket
Distance sensor
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the ...