Exploded View

![]() |
Flame assembly | ![]() |
Front final drive assembly | ![]() |
Front cross member assembly |
| : vehicle front | |||||
: N·m (kg-m, ft-lb) |
|||||
: Always replace after every disassembly. |
|||||
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Drain gear oil. Refer to Draining.
Remove front stabilizer clamps. Refer to Removal and Installation.
Remove both front drive shafts. Refer to Removal and Installation.
CAUTION:
Oil may leak from the opening. Use cap and/or plug to prevent leakage.
Remove front cross member assembly
.

Remove front propeller shaft from front final drive. Refer to Removal and Installation.
Remove air breather hose from front final drive. Refer to Removal and Installation.
Set a suitable jack to front final drive assembly.
Remove front final drive assembly mounting bolts and nuts (
), then remove front final drive assembly.

CAUTION:
Secure front final drive assembly to suitable jack while removing it.
INSTALLATION
Note the following, install in the reverse order of removal.
-
For each tightening torque, refer to Exploded View.
-
Perform inspection after installation. Refer to Inspection.
Inspection
INSPECTION AFTER INSTALLATION
Check the oil level and the oil leakage after installation. Refer to Inspection.
Other materials
Rear Oil Seal
Exploded View
Transfer assembly
Rear oil seal
: vehicle front
: Always replace after every disassembly.
: Apply transfer fluid.
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/ ...
Diagnosis and Repair Work Flow
Work Flow
DETAILED FLOWINTERVIEW FROM THE CUSTOMER
CAUTION:
Customers are not professional. Never guess easily like “maybe the customer means that...,� or “ maybe the customer mentions this symptom�.
>>
GO TO 2.
CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, ...
Mac Key Writing
Description
When replacing BCM, it is necessary to write MAC key to BCM. Write MAC key to BCM according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.CAUTION:
During MAC key writing, maintain the following conditions:
Ignition switch ON
CONSULT is connecte ...


: N·m (kg-m, ft-lb)
: Always replace after every disassembly.