Hydraulic Layout

![]() |
EVAP canister purge volume control solenoid valve | ![]() |
EVAP resonator | ![]() |
EVAP line |
![]() |
Fuel line | ![]() |
Fuel tank | ![]() |
Fuel filler neck |
![]() |
EVAP canister |
Quick Connector
CAUTION:
-
After connecting fuel tube quick connectors, check quick connectors are secure.


: Quick connector 
: Retainer 
: Hard tube (or the equivalent) 
: Connection (cross-section) 
: Resin tube 
: To under floor fuel line 
: To fuel tank 
: Tab 
: Disconnection -
Ensure that connector and resin tube never contact any adjacent parts.
Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
-
Inspect fuel lines, fuel filler cap and fuel tank for improper attachment, leakage, cracks, damage, loose connections, chafing or deterioration.


: Engine 
: Fuel line 
: Fuel tank -
If necessary, repair or replace damaged parts.
Other materials
Rear automatic air conditioning system
Basic information
The rear automatic climate control system in the Nissan Armada is engineered
to provide enhanced comfort for all passengers, especially those seated in the second
and third rows. When the front air conditioning system of the Nissan Armada is activated,
the rear system become ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG� and “SEAT BELT PRE-TENSIONER�, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...
Parameter Writing
Work Procedure
DescriptionWhen replace each camera, it is necessary to write the camera parameters using CONSULT.Write to around view monitor control unit according to "Parameter writing" procedure of "CONSULT Operation Manual".Work ProcedurePARAMETER WRITING
CONSULT
Ignition switch ON.
Select " ...




