Exploded View
 |
High-mounted stop lamp harness |  |
Rear spoiler |  |
High-mounted stop lamp |
 |
: Pawl | ||||
 |
: N·m (kg-m, in-lb) | ||||
Removal and Installation
CAUTION:
Disconnect battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal.
REMOVAL
Remove rear spoiler cover. Refer to Removal and Installation.
Remove high-mounted stop lamp fixing screws 
.
Disconnect high-mounted stop lamp harness connector .
Disengage high-mounted stop lamp fixing pawls , and then remove high-mounted stop lamp.
INSTALLATION
Install in the reverse order of removal.
Replacement
CAUTION:
Disconnect battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal.
HIGH-MOUNTED STOP LAMP
CAUTION:
Replacement of a single part is not possible due to the adoption of LED. For replacement, replace high-mounted stop lamp as a set. Refer to Removal and Installation.
Other materials
Precautions for Removing Battery Terminal
PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time ev ...
Brake Caliper Assembly
Exploded View
REMOVAL
Brake caliper assembly
: N·m (kg-m, ft-lb)
DISASSEMBLY
Cap
Bleeder valve
Cylinder body
Sliding pin
Sliding pin boot
Bushing
Torque member
: vehicle front
: ...
Steering Tilt
Diagnosis Procedure
CHECK STEERING TILT MECHANISM
Check for the following.
Mechanism deformation or pinched foreign materials.
Interference with other parts because of poor installation.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning par ...