Removal and Installation
REMOVAL
Disengage fixing pawls using a remover tool (A) according to numerical order 1 → 2 indicated by arrows as shown in figure, and then remove sliding switch knob.
 |
: Pawl |
Disengage fixing pawls using a remover tool (A), and then remove reclining switch knob.
|
: Pawl |
Remove outside seat cushion finisher outer. Refer to Disassembly and Assembly.
Remove power seat switch fixing screws 
and then remove power seat switch.
INSTALLATION
Install in the reverse order of removal.
Other materials
Engine Coolant
Inspection
LEVEL
Check if the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool.
: MAX
: MIN
Adjust the engine coolant level if necessary.
WARNING:
Never remove reservoir tank cap when engine is hot.
CAUTION:
Refill Genuine NISSAN Long Lif ...
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference
FRONT AXLE
Noise Shake Vibration Shimmy Judder Poor quality ride or handling
Improper installation, looseness
...
Wheel Alignment
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
DESCRIPTIONMeasure w ...