Exploded View

![]() |
Side oil seal | ![]() |
Front final drive assembly | ||
: Always replace after every disassembly. |
|||||
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Drain gear oil. Refer to Draining.
Remove both front drive shafts from front final drive assembly. Refer to Removal and Installation.
Remove side oil seal, using oil seal remover (A) (commercial service tool).

CAUTION:
Never damage gear carrier.
INSTALLATION
Using the drifts (A and B), drive side oil seal until it becomes flush with the gear carrier end.

| A | : Drift [SST: ST30720000 (NI-25405)] |
| B | : Drift [SST: ST27863000 ( — )] |
NOTE:
For left side, use drift [SST: ST30720000 (NI-25405)] only.
CAUTION:
-
Never reuse oil seal.
-
When installing, never incline oil seal.
-
Check that the oil seal lip is filled up with grease.
Install both front drive shafts. Refer to Removal and Installation.
Refill gear oil to the final drive. Refer to Refilling.
Perform inspection after installation. Refer to Inspection.
Inspection
INSPECTION AFTER INSTALLATION
Check oil level and final drive for oil leakage. Refer to Inspection.
Other materials
Instrument panel
Example
The instrument panel of the Nissan Armada combines traditional controls with
advanced digital interfaces, delivering a seamless driving experience. The layout
ensures that all critical vehicle information and multimedia functions are easily
accessible to the driver.
Side venti ...
NISSAN All-Mode 4WD system
The NISSAN All-Mode 4WD system in the Nissan Armada is engineered to deliver
maximum versatility and control by offering multiple selectable drive modes, including
AUTO, 4H, and 4L (if equipped). This intelligent system allows the driver to adapt
the Nissan Armada to a wide range of road and o ...
Oil Cooler
Exploded View
Oil cooler
O-ring
Oil filter
Connector bolt
Oil catch plate
Clamp
Oil cooler hose 2
Oil cooler hose 3
Oil cooler pipe 2
Oil cooler hose 1
Oil cooler pipe 1
Comply with the installation procedure when tightening. Refer to Removal and ...


: Always replace after every disassembly.