Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Sunshade Motor Assembly

Exploded View

Refer to Exploded View.

Removal and Installation

REMOVAL

CAUTION:

  • Before removing sunshade motor, check that sunshade is fully opened.

  • After removing sunshade motor, never attempt to rotate sunshade motor assembly as a single unit.

Remove headlining to make work space. Refer to Removal and Installation.

Disconnect harness connector, and then disengage harness connector assembly fixing clip.

Remove fixing screws , and then remove sunshade motor assembly.

INSTALLATION

CAUTION:

  • Install moonroof motor assembly and sunshade motor assembly in correct position without mistake.

  • Before installing the sunshade motor assembly, always place the link and wire of sunshade slider in the symmetrical and fully opened position.

Move the sunshade motor assembly laterally a little so that the gear is completely engaged into the wire on the moonroof unit assembly and mounting surface becomes parallel. Then secure the sunshade motor assembly with screws.

Install harness connector assembly, and then connect harness connector.

Install headlining. Refer to Removal and Installation.

CAUTION:

After installing sunshade motor assembly, perform additional service. Refer to Description.

    Other materials

    Engine Lubrication System Service Data and Specifications
    ENGINE OIL ENGINE OIL CAPACITY (APPROXIMATE)Unit: (US qt, lmp qt) Drain and refill With oil filter change 6.0 (6-3/8, 5-2/8) Without oil filter change 5.6 (5-7/8, 4-7/8) Dry engine (Overhaul) 7.2 (7-5/8, 6-3/8) Engine Oil Pressure Unit: kPa (kg/cm2, psi) Engine speed Approximate ...

    Wind Deflector
    Exploded View Refer to Exploded View. Removal and Installation REMOVALFully open the glass lid. Disengage wind deflector fixing points using a remover tool (A) from moonroof unit assembly. Remove wind deflector. INSTALLATIONInstall in the reverse order of removal. ...

    Repairing Material
    Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially available Urethane foam for sealant (foam materi ...