NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Torque Converter and Converter Housing Oil Seal

Nissan Armada 2025-2026 Service and Repair Manual / Transmission & Driveline / Transaxle & Transmission. 9at: Ge9r01a / Torque Converter and Converter Housing Oil Seal

Exploded View

A/T assembly Converter housing oil seal Seal ring
Torque converter      
: Always replace after every disassembly.
: Apply ATF

Removal and Installation

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

REMOVAL

Remove A/T assembly. Refer to Removal and Installation (2WD), Removal and Installation (4WD).

Remove torque converter by holding it firmly and turning while pulling straight out.

Remove seal ring from input shaft.

CAUTION:

Never reuse seal ring.

Remove converter housing oil seal.

CAUTION:

Never reuse converter housing oil seal.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Never reuse seal ring.

  • Never reuse converter housing oil seal.

  • Check dimension (A) between torque converter and torque converter housing as shown.

    Dimension (A) : Refer to Torque Converter.
    (B) : Scale
    (C) : Straight edge

Adjustment

ADJUSTMENT AFTER INSTALLATION

When replaced the torque converter, perform "TORQUE CONVERTER CLUTCH POINT LEARNING". Refer to Descripton.

    Other materials

    Warning/indicator lights (red)
    Brake warning light or In the Nissan Armada, the brake warning light is a critical safety indicator that helps monitor the condition of the braking system. When the ignition switch is turned to the ON position, this light should illuminate briefly for a few seconds and then turn off, ...

    Does Not Operate
    Diagnosis Procedure Automatic brake hold function does not operate when the operating conditions are satisfied.PERFORM SELF-DIAGNOSIS (CHASSIS CONTROL MODULE) With CONSULT Perform self-diagnosis for “CHASSIS CONTROL”. Is DTC detected? YES>> Check the DTC. Refer to DTC Index. NO>> G ...

    Normal Operating Condition
    Description FRONT WIPER MOTOR PROTECTION FUNCTION The CPU integrated in the front wiper motor may stop the front wiper to protect the front wiper motor if any obstruction (operation resistance) such as a large amount of snow is detected during the front wiper operation. At that time turn OFF the ...