Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Vdc Warning Lamp, Abs Warning Lamp and Brake Warning Lamp Turn on

Description

ABS warning lamp and Brake warning lamp turn ON for a moment when restating the engine.

Diagnosis Procedure

CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

With CONSULT

  1. Start the engine.

    CAUTION:

    The vehicle must be in a stopped state.

  2. Connect booster battery (12V) and jumper cable to 12V battery cable.

  3. Select “Active test� in “ENGINE�.

  4. Select “Auto stop start� in “Active test�.

  5. Touch “Start�.

    CAUTION:

    • Since the engine runs with the hood open, special care must be taken when performing the work.

    • If the idling stop state cannot be developed. Refer to System Description.

  6. Check the ABS warning lamp state and the brake warning lamp state when “Cancel� is touched under the idling stop state.

Are the VDC warning lamp, ABS warning lamp and the brake warning lamp OFF?

YES>>

Check the 12V battery. Refer to Work Flow.

NO>>

GO TO 2.

PERFORM THE SELF-DIAGNOSIS

With CONSULT

  1. Turn the ignition switch OFF → ON.

    CAUTION:

    • Be sure to wait of 10 seconds after turning ignition switch OFF or ON.

    • Start the engine.

  2. Repeat step 1 two or more times.

  3. Perform self-diagnosis for “ABS�.

Is any DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

INSPECTION END

    Other materials

    Rear Propeller Shaft
    Exploded View REMOVAL Propeller shaft assembly : vehicle front : N·m (kg-m, ft-lb) : Always replace after every disassembly. DISASSEMBLY Snap ring Journal bearing Journal Flange yoke Propeller shaft (1st shaft) Propeller shaft (2nd shaft) : vehicle front : Alw ...

    Precautions
    PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal� described below. NOTE: Some ECUs operate for a certain fixed time ev ...

    Front Fog Lamp Aiming Adjustment
    Adjustment PREPARATION BEFORE ADJUSTINGNOTE: For details, refer to the regulations in your own country.Before performing aiming adjustment, check the following. Adjust the tire pressure to the specification. Fill with fuel, engine coolant, and each oil. Maintain the unloaded vehicle condition. ...