Exploded View
 |
Bracket |  |
A/T assembly |  |
Air breather hose |
 |
Clip | ||||
 |
: N·m (kg-m, ft-lb) | ||||
 |
Always replace after every disassembly. | ||||
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Remove fender protector RH. Refer to Removal and Installation.
Remove 12V sub battery (lithium ion battery) harness 1 bracket. Refer to Exploded View (If necessary).
Release clip 
and remove air breather hose assembly from bracket .
Separate the air breather hose from air breather tube and remove air breather hose.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
Install air breather hose so that painted mark
on it and arrow mark 
of breather faced forward of the vehicle.
: vehicle front -
When inserting the air breather hose
into the breather connector, insert it until it hits the painted mark on the breather connector.
Other materials
Rear Final Drive Assembly
Exploded View
Final drive mounting bracket
Rear final drive assembly
Upper stopper
Lower stopper
Washer
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to g ...
Back Door Auto Closure Control Unit
Removal and Installation
REMOVALRemove luggage side lower finisher LH. Refer to Removal and Installation.
Disconnect back door auto closure control unit harness connector.
Remove back door auto closure control unit mounting nuts , and then remove back door auto closure control unit .
INSTALLATIONIn ...
Led Headlamp Operation Inspection
Work Procedure
CHECK START
In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
In the cool LED status, turn headlamp ON, wait until headlamp enters to the stable s ...