Removal and Installation
REMOVAL
Remove luggage rear plate. Refer to Removal and Installation.
Remove mounting TORX bolts, and then remove back door striker.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Never reuse TORX bolt. Always replace it with a new one when it is removed.
-
Before tighten back door striker mounting TORX bolts to the specified torque, perform the fitting adjustment. Refer to Adjustment.
Other materials
Interior lights
Basic information
CAUTION
In the Nissan Armada, avoid leaving interior lights switched on for extended
periods when the engine is not running, as this may lead to battery discharge.
Always switch off all interior lighting before leaving the Nissan Armada
to preserve battery life and ens ...
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
NVH Troubleshooting chartUse the Chart Below to Help You Find the Cause of the Symptom
Locate the area where noise occurs.
Confirm the type of noise.
Specify the operating condition of the engine.
Check specified noise source.
If necessary, ...
Tilt & Telescopic Switch
Removal and Installation
REMOVALRemove steering column cover lower. Refer to Removal and Installation.
Disengage the fixing pawls using a remover tool (A) and then remove tilt & telescopic switch.
: Pawl
INSTALLATIONInstall in the reverse order of removal. ...