Description
The easy fill tire alert does not function while inflating a tire when the selectposition is in P-range with the ignition switch ON or with the engine started.
NOTE:
-
After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to function.
-
If there is no response for approximately 15 seconds or more after inflating the tires, cancel the use of the easy fill tire alert function or move the vehicle approximately 1 m (3.2 ft) backward or forward to try again. The air filler pressure may be weak or out of service area.
-
For easy fill tire alert, Refer to Easy Fill Tire Alert Function.
Diagnosis Procedure
LOCATION CHANGE
Move the vehicle to other area and repeat the procedure of the easy fill tire alert function. Refer to Easy Fill Tire Alert Function.
Is the function normal?
YES>>Normal (the tire inflation indicator may not operate, depending on reception condition.)
NO>>GO TO 2.
PERFORM LOW TIRE PRESSURE MONITORING SYSTEM SELF DIAGNOSTIC RESULT
With CONSULT
-
Drive for 10 minutes at a speed of 25 km/h (16 MPH) or more.
-
Stop the vehicle.
-
Perform “Self Diagnostic Result“ for “AIR PRESSURE MONITOR“.
Is any DTCs detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>GO TO 3.
CHECK HAZARD WARNING LAMP OPERATION
Check hazard warning lamp operation with hazard switch.
Does the hazard warning lamp blink?
YES>>GO TO 4.
NO>>Perform trouble diagnosis for the hazard warning lamp. Refer to Symptom Table.
PERFORM TCM SELF DIAGNOSTIC RESULT
With CONSULT
Perform “Self Diagnostic Result“ for “TRANSMISSION”.
Is any DTCs detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>GO TO 5.
CHECK HORN OPERATION
Check horn operation.
Is the operation normal?
YES>>GO TO 6.
NO>>Repair or replace error-detected parts.
PERFORM BCM SELF DIAGNOSTIC RESULT
With CONSULT
Perform “Self Diagnostic Result” for “BCM”.
Is any DTCs detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>Replace BCM. Refer to Removal and Installation.
Other materials
How to switch the display
With the ignition switch in the ON position, the Nissan Armada Intelligent Around
View Monitor can be activated either by pressing the CAMERA/
button or by shifting the transmission into the R (Reverse) position.
Once activated, the Nissan Armada system automatically presents different split- ...
Electrical Brake Control Unit
Exploded View
Reservoir cap
Electrical brake control unit
Bracket
Caution label
Gasket
Spacer
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
Removal & Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle ...
Rear Door Hinge
Removal and Installation
REMOVALRemove rear door assembly. Refer to Removal and Installation.
Remove rear door hinge mounting bolts, and then remove rear door hinge from vehicle body.INSTALLATIONNote the following items, and then install in the reverse order of removal.CAUTION:
Before installation ...