Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation

Refilling

WARNING: Remove engine under cover. Refer to Exploded View. Remove filler plug and gasket. Then fill with new gear oil until oil level reaches the specified level near filler plug mounting hole. ...

Front Oil Seal

...

Other materials:

Work Procedure
CHOOSE METHOD There are two ways of initialization method. Which method do you choose? With CONSULT>> GO TO 2. Without CONSULT>> GO TO 3. WITH CONSULT With CONSULT Ignition switch ON.Perform "Third seat LH position initialization" in "Work support" mode of "THIRD SEAT RH" using CONSUL ...

Precautions for Removing Battery Terminal
NOTE: NOTE: NOTE: The removal of 12V battery may cause a DTC detection error. HOW TO DISCONNECT 12V BATTERY TERMINAL Disconnect 12V battery terminal according to instruction described below. Open the hood. Turn ignition switch to the ON position. Turn ignition switch to the OFF position with the d ...

Calibration of Yaw Rate Sensor
CAUTION: Always perform the yaw rate sensor calibration before driving when the following operation is performed. Refer to Work Procedure. ×: Required —: Not required Procedure Yaw rate sensor calibration Removing/ installing ABS actuator and electric unit (control unit) × Replacing ABS act ...